car wont go into gear after clutch install

So first thing is first. I bled the system but for some reason the pedal still feels the same so i.

How Dual Clutch Transmissions Work

This then caused the clutch disc to sit at an angle when it was installed.

. Just finished putting everythig back together. What to Do When Your Car Wont Go into Gear Skip Ahead to Section Below. Again makes no financial sense when the whole system is sealed and working perfectly fine.

Press the Clutch Pedal Down More. OK heres the scoop. The car starts moving if you push it to 1st.

Now the car wont go into gear with the engine running. While your at it might as well change the old rubber clutch line for a SS line. Sticking gears could indicate a clutch problem if you have a manual transmission.

Postby JonathanPrem Mon Apr 25 2011 155 pm. Also when i start it in first and barely lift up the pedal to go it will diei tried adjusting the rod according. That caused the clutch disc to be in constant contact with the flywheel and pressure plate.

Press the clutch down more and try to change gears again. Remove the clutch disc and inspect the spline at the center. Hey peeeps This winter i upgraded my clutch to stage 4 so later on i can boost my KA24de.

IT will go into first car before the car starts but just trying the other gears feels weird it doesnt fully go in and it feels sloppy. Or Make Sure to Press Down the Brake. If your car wont go into gear here are some things to try to solve your problems.

I just installed another dohc zc in a guys 88si. My slave bleeder was rusted to i replaced it with a new one from dealer. I do suggest flushing the fluid tho.

If you have a manual transmission try to press the clutch pedal all the way down to. Push the Clutch Harder. A few months back I installed a Mcleod clutch flywheel and ss line along with new Ford slave and RP trans fluid.

You are then having to flush the system and make sure there is no air in the system as you have installed all new parts. Try this on the clutch pedal. If you have a manual transmission theres a chance you didnt press the clutch all the way to the floor before changing gears.

Sometimes its impossible to go into 1st or reverse. Transmission wont go into gear after clutch installed. I got a clutch disc where the spline was not machined straight thru but instead was machined at an angle.

Depress the Clutch More. Releasing the clutch pedal reengages the pressure plate and flywheel to get you moving again. I have had the system bled numerous times by different places.

Naturally I changed the clutch ebay-ish stage 2 throw out bearing and pilot bearing. Theres is a screw I cant recall which direction but your pedal should be a bit higher turn screw 2 or 3 times then test it out-- since its an aftermarket clutch it wont engage how it did before so you have to adjust clutch pedal same thing happen to me hopefully it works for you matt58veedub Registered. Discussion Starter 1 Aug 13 2017.

A couple of months ago I posted regarding my clutch issues. I was having trouble getting the car into 1st or second and then eventually into reverse. It will with the engine.

If you have an automatic transmission and cannot move the shift. The parts used - Competition Stage 3 clutchPressure plate-Resurfaced OEM exedy flywheel with 38k A buddy of mine who also drives and FRS successfully installed a new clutch on his so I figured he would be the right person to help me with my clutch issue I was experiencing. Pressing the pedal down disengages the clutch system which is necessary to switch gears.

Sometimes to get the car into gear i had to shut the car off to get it into gear.

Diy Tips Replacing Your Clutch Isn T That Hard